DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 14 CONFIGURATION FILE ACCESS / REQUEST ERROR
Event 14 CONFIGURATION FILE ACCESS / REQUEST
ERROR
CONFIGURATION ACCESS ERROR
Description: This error message is the result of trying to access the configuration file
and being unsuccessful.
CONFIGURATION FILE ACCESS / REQUEST ERROR
Description: Configuration file access error - cannot access incarnation number.
Telcon generates this CENLOG.
Action: If this event occurs frequently, retrieve the configuration file and start a
batch run to activate the program.
PDNMS
Description: The X.25 PSCS NMS processing module (PDNMS) received an X.25
PSCS specific NMS command, but X.25 PSCS is not initialized.
Attributes affected: Configuration event. The X.25 PSCS program product
generates this CENLOG. Procedure: PDNMS.
Action: Verify that at least one of X.25 PSCS’s lines has been enabled on a valid line
module using an NMS UP LINE command. If a line has already been enabled, then
X.25 PSCS may currently be initializing, or an initialization error has occurred and has
been recorded with a CENLOG class/event of 5/15 with a supplementary text message
of: “PSCS initialization error.”
PPID NOT FOUND
RTC
Description: During line termination (module PDNSVS) was unable to successfully
access one of its link layer table (Z2$) entries. PDNSVS was unable to obtain a match
based on the LINE STE index contained in the line control block (LCB).
Attributes affected: Line event, Configuration event. The X.25 PSCS program
product generates this CENLOG. Procedure: PDNSVS.
Action: Online configuration changes to the LINE statement may require Telcon to
be restarted. If this event occurs after Telcon is restarted, then a software error has
either corrupted the LINE STE index in the PDNSVSs link- layer table or in the LCB.
Description: A configuration error occurred while processing the ROUTE
configuration statements. Telcon generates this CENLOG.
7436 0728–303 5–71