DCP Series Telcon Message Manual - Public Support Login - Unisys

SNMP 210 Bad ICS connect status xxxx
Event 11 ILM EVENT
Description: The SNMP Agent received a bad status trying to establish an ICS
connection. The connection has not been made.
Variable: xxxx The ICS status value.
Action: If this CENLOG occurs repeatedly, dump the ILM as close as possible to an
occurrence.
SNMP 211 Bad ICS send status xxxx
Description: The SNMP Agent received a bad status trying to send data on an ICS
connection. The data message is discarded.
Variable: xxxx The ICS status value.
Action: If this CENLOG occurs repeatedly, dump the ILM as close as possible to an
occurrence.
SNMP 212 No memory for CCB
Description: The SNMP Agent could not get ILM memory to build a connection
control block. Although the connection exists, no control block is built to be able to
use it.
Action: This CENLOG indicates a tight memory situation in the ILM. If the ILM is not
currently under heavy load, then an internal error could have occurred which
consumed a lot of memory. Dump the ILM.
SNMP 213 No config access. Using defaults.
Description: During system initialization, the SNMP Agent waits to be contacted by
CIM-ILM in order to read its configuration. If forty-five seconds (current value) has
elapsed without this contact, the SNMP Agent continues initialization with the default
configuration. The default configuration is equivalent to the following (where pp is
the port number).
[PORTpp]
[SNMP]
Action: Dump the ILM.
7436 0728–303 6–99