DCP Series Telcon Message Manual - Public Support Login - Unisys

Section 14
Class 14 CENLOG Messages
CENLOGs in Class 14 result from unrecoverable communication line errors.
Event 1 LINE CONNECTION (UNSUCCESSFUL)
LINE CONNECTION (UNSUCCESSFUL)
Description: An unsuccessful attempt was made to connect an external line. Telcon
generates this CENLOG.
Action: Check all applicable hardware and repair or replace as necessary. If
hardware is operational, check system configuration information for completeness
and correctness; that is, UDLC station addresses, dial-out phone numbers, and dialer
line module port IDs.
UDLCRS
Description: R8: 0010. AE$UD102. (UDLC): NO HCB. The line is connected
physically and the remote station is known, but there is no HCB for the high-level
entity with which the station is associated. Telcon generates this CENLOG.
UDLCRS
Description: R8: 0011. AE$UD103. (UDLC): CONFIG READ ERROR ON LINE
TABLE - CHECK CONFIG/DISK. The line is connected physically, but an error
occurred accessing the line information table. Telcon generates this CENLOG.
UDLCRS
Description: R8: 0012. AE$UD104. (UDLC): CONFIG READ ERROR ON GROUP
TABLE - CHECK CONFIG/DISK. The line is connected physically, but an error
occurred in accessing the group information table. Telcon generates this CENLOG.
UDLCRS
Description: R8: 0013. AE$UD1015. (UDLC): CONFIG READ ERROR ON STATION
TABLE - CHECK CONFIG/DISK. The line is connected physically, but an error
occurred in accessing the station information table. Telcon generates this CENLOG.
7436 0728–303 14–1