DCP Series Telcon Message Manual - Public Support Login - Unisys

2028 TELNET MISC ERROR IN TELNET VALIDATION
Event 12 TCP–IP GATEWAY EVENT
Description: An error was detected while processing the message. The following
information should be recorded and given to the site analyst:
R13: Current connection states — inbound (upper 4 bits)/outbound (next 4
bits)/(next 8 bits unused). Connection state codes found in TELNET.
R14: PK$MTYPE/PK$ERROR — message type (8 bits)/error code (8 bits) from
current message packet. Message types and error codes found in
AADDNDEF.
R15: Error code. Error codes found in AADDNDEF.
The TELNET module generates this CENLOG.
2200 TELNET INV FUNCTION CODE
Description: An invalid parameter was passed to the protocol manager routine. The
TELNET module generates this CENLOG.
2201 TELNET UNSPEC ERROR: PMA PMAXEU10
Description: TCP–IP Stack detected an error in the interface to another software
component. This condition is normally recoverable. The TCP–IP Stack program
product generates this CENLOG.
Action: If the condition persists, contact your support center.
2202 TELNET INTERNAL PROT MGR ERROR
Description: The presentation services routine rejected the calling parameters set up
by the protocol manager routine. The TELNET module generates this CENLOG.
2203 TELNET INV COMMAND : PMC
Description: TCP–IP Stack detected an error in the interface to another software
component. This condition is normally recoverable. The TCP–IP Stack program
product generates this CENLOG.
Action: If the condition persists, contact your support center.
2400 TELNET CASE LIMIT ERROR: CMS_SVS
Description: An internal error was detected in the command services routine. The
TELNET module generates this CENLOG.
7436 0728–303 3–69