DCP Series Telcon Message Manual - Public Support Login - Unisys

XFER n-dcpname ABORT–DCP FILE IS EMPTY
NMS and DSA Messages
Description: The file transfer failed because the specified DCP file is empty.
XFER n-dcpname ABORT–DCP FILE IS NOT A PROGRAM FILE
Description: This DCP file is a data file only. It does not contain any elements.
XFER n-dcpname ABORT–DCP FILE TOO SMALL
Description: The specified DCP file is too small to accommodate the file transfer.
Action:
1. Delete and recatalog the file with sufficient size to accommodate the file being
transferred.
2. Catalog an alternate file with sufficient size to accommodate the file being
transferred.
XFER n-dcpname ABORT–DCP PHYSICAL I/O ERROR
Description: The file transfer failed because of a DCP physical input or output error.
XFER n-dcpname ABORT–HOST FILE TOO SMALL
Description: The specified host file is too small to accommodate the file transfer.
XFER n-dcpname ABORT–INTERNAL ERROR
Description: A software error fatal to file transfer n-dcpname has occurred in the
XFER software.
XFER n-dcpname ABORT–SESSION CANNOT BE OPENED TO HOST
Description: The transfer program (XFER) cannot open a session to the host
specified by the XEU name input as a HOSTID on the transfer command (XFER).
XFER n-dcpname ABORT–SESSION PATH DOWN
Description: The XFER session to the host has been closed.
XFER n-dcpname ABORT–USE (+1) RELATIVE FILE CYCLE
Description: The host file specified as the transfer destination (using the XFER
command) does not exist. Therefore, an absolute file cycle is invalid because the
transfer command (XFER) cannot create an absolute cycle.
7436 0728–303 17–35