DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
X.25 Clear by Network–Cause,Diagnostic=hhhh,hhhh
Description: The Common Network Management Service (CNMS) X.25 interface
module in PDNSVS received an alarm notification. (CNMS does not need to be
operating for this CENLOG to be enabled.) The layer 3 module received Clear packet
from the network for a particular virtual circuit. This event includes the LINE name
and could include the DTE statement name or address information.
R8: PDNGRP STE index
R9: Logical channel number
R10: Packet’s cause code. See Appendix C of this manual for a description of the
cause code.
R11: Packet’s diagnostic code. See Appendix A of this manual for a description of
the diagnostic code.
R12: CNMS alarm code
R13: Layer 4 routing identifier
Attributes affected: Supplementary text message, Line event, Device event (if the
clear [reset] packet is associated with a configured DTE statement and CSNM is not
active), can include CNMS interface packet. The X.25 PSCS program product
generates this CENLOG. Procedure: PDNSVS.
X.25: DEFAULT LEVEL 4 NOT ALLOWED FOR LEVEL 4 TYPE
Description: X.25 PSCS received an incoming call packet from the network. The
X25ROUTE statement’s LEVEL4 parameter is used to configure a default layer 4, but
X.25 PSCS does not support this layer 4 as a default.
R9: Level 4 routing id (ZH$ Equate).
Attributes affected: Supplementary text message. The X.25 PSCS program product
generates this CENLOG. Procedure: PCALL.
Action: Modify the X25ROUTE statement.
13–62 7436 0728–303