DCP Series Telcon Message Manual - Public Support Login - Unisys

Sense Data
IBM/Unisys Request Reject (Category X'08')
D–8
Indicates that the request was delivered to the intended component and was understood
and supported, but not executed.
The sense code is in hexadecimal.
0801 Resource Not Available. The LU, PU, station, or link specified in an RU is not
available.
0802 Intervention Required. Forms or cards are required at an output device, or a
device is temporarily in local mode, or other conditions require intervention.
0803 Missing Password. The required password was not supplied.
0804 Invalid Password. Password was not valid.
0805 Session Limit Exceeded. The requested session cannot be activated because
one of the NAUs is at its session limit. For example, the LU–LU session limit or
the (LU, mode) session limit. This sense code applies to ACTCDRM, INIT,
BIND, and CINIT requests.
0806 Resource Unknown. For example, the request contained a name or address not
identifying a PU, LU, SSCP, link, or link station known to the receiver or the
sender.
In an interconnected network environment, this sense code may be set by an
SSCP in whose subnetwork and domain the LU was expected to reside; it is not
set by an SSCP that is only an intermediary on the session-setup path. A
gateway SSCP examines the Resource Identifier control vector in a sessionsetup
request (for example, CDINIT) to determine whether the LU is in the
SSCP's subnetwork and domain.
0807 Resource Not Available–LUSTAT Forthcoming. A subsidiary device will be
unavailable for an indeterminate period of time. LUSTAT is sent when the
device becomes available.
0808 Invalid Contents ID. The contents contained on the ACTCDRM request was
found to be invalid.
0809 Mode Inconsistency. The requested function cannot be performed in the
present state of the receiver.
080A Permission Rejected. The receiver has denied an implicit or explicit request of
the sender.
When sent in response to BIND, it implies either that the secondary LU will not
notify the SSCP when a BIND can be accepted or that the SSCP does not
recognize the NOTIFY vector key X'0C'. (See the X'0845' sense code for a
contrasting response.)
7436 0728–303