DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 8 SYSTEM SERVICE CALL EXCEPTION STATUS
Load Fail on Port XXX (no file or elt)
Description: The load element for an ILM has the hardware type appended to the
load file name. In an attempt to initialize a line, the ILM Platform could not locate a
loadfile for the appropriate hardware type.
Action: Ensure the correct ILM load element exists in the ‘Run Qualifier’*ILMLOAD
file.
SNA: 1603 - Error =x%%%% in extending segment for PCB
Description: This message appears as a result of errors in DTPLNK, the part of
SNA/net that enables SNA/net to communicate with other SNA/nets as if they were
physically adjacent. The word error in the message represents a specification error in
DCA. Where x%%%% represents a hexadecimal number. Refer to the Telcon
Programming Reference Manual (7436 0710) for further information. The probable
cause is a software problem.
SNA: 1604 - Error =x%%%%, creating segment for PCB
Description: This message appears as a result of errors in DTPLNK, the part of
SNA/net that enables SNA/net to communicate with other SNA/nets as if they were
physically adjacent. The word error in the message represents a specification error in
DCA. The x%%%% represents a hexadecimal number. Refer to the Telcon
Programming Reference Manual (7436 0710) for further information. Probable
causes include a resource availability (out of memory, out of disk storage) or software
problem.
SNA: 1605 - Error =x%%%% putting PCB segment in PST
Description: This message appears as a result of errors in DTPLNK, the part of
SNA/net that enables SNA/net to communicate with other SNA/nets as if they were
physically adjacent. The word error in the message represents a specification error in
DCA. The x%%%% represents a hexadecimal number. Refer to the Telcon
Programming Reference Manual (7436 0710) for further information. The probable
cause is a software problem.
SNA: 1606 - Error =x%%%% getting send queue number
Description: This message appears as a result of errors in DTPLNK, the part of
SNA/net that enables SNA/net to communicate with other SNA/nets as if they were
physically adjacent. The word error in the message represents a specification error in
DCA. The x%%%% represents a hexadecimal number. Refer to the Telcon
Programming Reference Manual (7436 0710) for further information. The probable
cause is a software problem.
7436 0728–303 12–9