DCP Series Telcon Message Manual - Public Support Login - Unisys

X.25 Restart by DCP–“reason"
Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
Description: The Common Network Management Service (CNMS) X.25 interface
module in PDNSVS received an alarm notification. (CNMS does not need to be
operating for this CENLOG to be enabled.) The layer 3 module sent a Restart packet
to the network on a particular network connection (line). This event includes the
LINE name.
R8: PDNGRP STE index
R10: Packet’s cause code. See Appendix C of this manual for a description of the
cause code.
R11: Packet’s diagnostic code. See Appendix A of this manual for a description of
the diagnostic code.
R12: CNMS alarm code
Attributes affected: Supplementary text message, Line event, may include CNMS
interface packet. The X.25 PSCS program product generates this CENLOG.
Procedure: PDNSVS.
X.25 Reset by Network–Cause,Diagnostic=hhhh,hhhh
Description: The Common Network Management Service (CNMS) X.25 interface
module in PDNSVS received an alarm notification. (CNMS does not need to be
operating for this CENLOG to be enabled.) The layer 3 module received Reset packet
from the network for a particular virtual circuit. This event includes the LINE name
and may include the DTE statement name or address information.
R8: PDNGRP STE index
R9: Logical channel number
R10: Packet’s cause code. See Appendix C of this manual for a description of the
cause code.
R11: Packet’s diagnostic code. See Appendix A of this manual for a description of
the diagnostic code.
R12: CNMS alarm code
R13: Layer 4 routing identifier
Attributes affected: Supplementary text message, Line event, Device event (if the
clear [reset] packet is associated with a configured DTE statement and CNMS is not
active), can include CNMS interface packet. The X.25 PSCS program product
generates this CENLOG. Procedure: PDNSVS.
7436 0728–303 13–67