DCP Series Telcon Message Manual - Public Support Login - Unisys

Table A–1. X.25 Diagnostic Codes
X.25 PSCS Diagnostic Codes
Code Diagnostic Source
Dec Hex
65 41 An incoming call packet was received
containing the priority facility, but the
OPTIONS=HIPRI on the PDNGRP
statement isn’t configured.
65 41 An incoming call packet contains a
facility code that is not allowed for
incoming call packets.
PSCS generated
PSCS generated
66 42 Facility parameter not allowed PDN, PSCS, DAD generated
66 42 An incoming call packet was received
containing an out-of-range facility
parameter value for the following
facility codes: window size, packet
size, fast select, reverse charging.
Check the configured window, packet
and frame sizes configured on the
WINSIZ and PAKSIZ parameters of the
DTETYPE statement and the N1
parameter on the X25DEF statement,
and the OPTIONS=(RVCHG,FASTSL)
parameter options.
66 42 A Call Accept Primitive was received
containing out-of-range packet or
window sizes. These values cannot
be larger than the values specified in
the Call Indication Primitive.
66 42 A call connected packet was received
containing out-of-range packet or
window sizes. These values cannot
be larger than the values specified in
the call request packet.
PSCS generated
PSCS generated
PSCS generated
67 43 Invalid called DTE address PDN, PSCS, DAD generated
67 43 An incoming call packet was received
and its called DTE address doesn’t
match the DTE address configured on
the DTEADR parameter of the
PDNGRP statement.
PSCS generated
68 44 Invalid calling DTE address PDN, PSCS, DAD generated
68 44 An incoming call packet was received
that is not configured to be accepted.
Check the X25ROUTE statement and
its parameters to verify the type and
content of the incoming call packets
that is allowed.
PSCS generated
7436 0728–303 A–5