DCP Series Telcon Message Manual - Public Support Login - Unisys

NO RECOVERY FILE–CANNOT CANCEL FACILITY MOVE
NMS and DSA Messages
Description: This is the response to the CNCL command when a system failure has
occurred during a facility move, but a recovery file is not cataloged.
Action: Reenter the MOVE command.
NON-CONFIGURED TERMINAL
Description: This error message is generated when a user sends a USM to a terminal
that does not exist.
Action: Check the configuration for the terminal, and reenter the command.
NOTE: NO X.25 TRUNKS CONFIGURED
Description: An X.25 trunk command was invoked and no X.25 trunks are
configured. This is an X.25 PSCS NMS message.
NOTE: PDTE dte-id NOT ACTIVE
Description: Part of the response to a DOWN PTRK command when the X.25 part of
a trunk is already marked down in the configuration, but is still in the process of being
brought to the down state. This is an X.25 PSCS NMS message.
NOTE: X.25 TRUNK trunk-id ALREADY DISABLED
Description: Part of the response to a DOWN PTRK command when the X.25 part of
a trunk is already marked down in the configuration, but is still in the process of being
brought to the down state. This is an X.25 PSCS NMS message.
NOTE: X.25 TRUNK trunk-id ALREADY ENABLED
Description: Part of a trunk is already marked up in the configuration, but is still in
the process of being brought to the up state. This is an X.25 PSCS NMS message.
PDTE dte-id NOT FOUND
Description: A command specified a DTE that is not in configuration. This is an
X.25 PSCS NMS message.
POLL GROUP UP ...
POLL GROUP UP, INPUT(STOPPED,ALLOWED),
OUTPUT(STOPPED,ALLOWED),n TERMINAL(S) ACTIVE,
(SPECIFIC,GENERAL,SLOW) POLLING
Description: The poll group exists.
7436 0728–303 17–25