DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 6 INVALID COMMAND / CONTROL / HIC RECEIVED
SNA: 2215 – Vr msg, bad state (&&), rh= %% %% %%, ru= %% %%
%%
Description: This message occurs as a result of a response being received from the
ERVR complex and the SNA trunk was not expecting it. The & represents a decimal
number, the % represents a hexadecimal number.
SNA: 2216 – Vr data received in bad state (&&)
Description: This message occurs when a session control message is received from
the ERVR complex while SNA trunk is not in the correct state. The & represents a
decimal number.
SNA: 2217 – Mparse err = %%%%, msg from vr, ru= %% %% %%
Description: This message occurs in SNA trunk when a message received from the
ERVR complex cannot be parsed correctly. The % represents a hexadecimal number
identifying the “Mparse” error and the request unit that could not be successfully
parsed.
SNA: 2218 – Mparse err = %%%%, cinit from snass
Description: This message occurs in SNA trunk when a CINIT is received from the
SNASS complex and it could not be correctly parsed. The % represents a hexadecimal
number identifying the “Mparse error.”
SNA: 2219 – Mparse build @@@@@@@@, err = %%%%
Description: This message occurs in SNA trunk when a message could not be built
successfully by the parsing complex. The @ represents an ASCII character and the %
represents a hexadecimal number.
SNA: 2220 – Invalid snass msg, function code = %%%%
Description: This message occurs in SNA trunk when an unknown message is
received from the SNASS complex. The % represents a hexadecimal number and
identifies the invalid message code.
SNA: 2221 – No cb, snass msg, name = @@@@@@@@, fc = %%%%
Description: This message occurs in SNA trunk when a message is received from the
SNASS complex and no control block could be found using the name of the control
block as the search key. The @ represents an ASCII character and the % represents a
hexadecimal number.
7436 0728–303 5–19