DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 12 TCP–IP GATEWAY EVENT
IP: IPADR CONFIG ERR, IPADR IP ADDRESS = !, LINE STE = #
LINE IP ADDRESS = !, MASK = !
Description: TCP–IP Stack detected a configuration error. The IP address specified
on an IPADR statement does not match the IPNETID specified by the SUBNET
statement that references the LINE, CHANNEL, or PDNGRP parameter referenced by
the IPADR statement. Some configured functions may not be available. The TCP–IP
Stack program product generates this CENLOG.
Action: Verify that all IP addresses and masks are specified correctly. Verify that
IPADR statements using the LINE, CHANNEL, or PDNGRP parameter refer to the
correct statement.
IP: IPADR CONFIGURATION ERROR, IP ADDR = !, LINE = #
Description: TCP–IP Stack detected a configuration error. There is no SUBNET
statement configured for the LINE, CHANNEL, or PDNGRP referenced by an IPADR
statement. Some configured functions may not be available. The TCP–IP Stack
program product generates this CENLOG.
Action: Verify that all IPADR statements using the LINE, CHANNEL, or PDNGRP
refer to the correct statement.
IP: IPADR nnn.nnn.nnn.nnn IN ERROR - BOTH LOCAL
Description: Configuration error. IPADR statement should not be used to specify
two local addresses at the same time.
IP: IPM SERVICE ERROR, R8 = ERROR, R9 = IPM ID
Description: TCP–IP Stack detected a system error. Some configured functions may
not be available. The TCP–IP Stack program product generates this CENLOG.
Action: If the problem persists, contact your support center.
IP: LA ENTRY IN USE, SHOULDN'T BE
Description: Fatal error. IP detected that its link area appeared to be corrupted.
Dump; then restart Telcon. The TCP–IP Stack program product generates this
CENLOG.
IP: LA ENTRY NOT IN USE, SHOULD BE
Description: A fatal error. IP detected that its link area appeared to be corrupted.
Dump; then restart Telcon. The TCP–IP Stack program product generates this
CENLOG.
3–42 7436 0728–303