DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 5 DYNAMIC SYSTEM SEGMENT ERROR
Event 5 DYNAMIC SYSTEM SEGMENT ERROR
RMLPH
Description: 15: Invalid call code. Telcon generates this CENLOG.
PDN Trunk is not configured
Description: The DCP-to-DCP module (PDNTRK) was unable to successfully
process a primitive across the Layer 3/4 Platform interface or some other item
received on its queue. he reason is because the PDNTRK initialization segment is not
present.
Attributes affected: Supplementary text message, configuration event. The X.25
PSCS program product generates this CENLOG.
Action: Review the X.25 PSCS’s configuration statements. If any DTE statements
have DTETYPE statements whose Level 4 equals PDNTRUNK, then verify that the
DTE statement references a valid TRUNK statement on its TRUNK parameter. Check
to see if the X25ROUTE statement is inadvertently routing call packets to the
PDNTRK module. Procedure: PDNTRK.
SNA: 1036 – Pub/Lub segment creation error
Description: This message occurs as a result of errors or events in terminals
attached to SNA/net. The probable cause is a software problem.
SNA: 1404 - Could not extend system segment
Description: This message occurs as a result of errors in SNMS, the part of SNA/net
that processes operator commands. The probable cause is a software problem.
SNA: 1405 – Maximum SCB segments created (err %%%%)
Description: This message occurs as a result of errors in SNMS, the part of SNA/net
that processes operator commands, where % represents a hexadecimal number. The
probable cause is a software problem.
SNA: 1406 – Could not extend system segment (err %%%%)
Description: This message occurs as a result of errors in SNMS, the part of SNA/net
that processes operator commands. The % represents a hexadecimal number. The
probable cause is a software problem.
7436 0728–303 5–7