DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 15 CONFIGURATION ERROR DETECTED / UNDEFINED
X.25: L4 Call Request Cleared, R11 = reason
Description: The layer 3 module (PDNL3) was unable to successfully process a Call
Request primitive received across the Layer 3/4 Platform interface. Instead of sending
a call request packet to the network, PDNL3 returned a Clear Indication primitive to
the layer 4 module.
R11: Clear primitive’s diagnostic code. For a description of error codes, refer
to Appendix B of this manual.
R12-R15: May contain the called DTE address digits
Attributes affected: Supplementary text message. The X.25 PSCS program product
generates this CENLOG. Procedure: PDNL3.
X.25 PSCS initialization error
Description: While processing the X.25 PSCS portion of the configuration, an invalid
condition occurred. Such conditions can include illegal statement or keyword
referenced, required statement or missing out-of-range keyword values, internal table
sizes exceed system segment size, or configuration access error. When an error
condition occurs, X.25 PSCS remains uninitialized (exceptions noted). Either an
online configuration change (restarting Telcon is not necessary) or a new, correct
configuration file is required to correct the error condition.
R8: Relative address offset in PDNIUS at which the error occurred
R9: Error code. For error code explanation, refer to Appendix B of this manual.
R10: Supplemental error information, if applicable. For error code explanation,
refer to Appendix B of this manual
R11: Line Control Block (LCB)
R12: Supplemental error information, if applicable. For error code explanation,
refer to Appendix B of this manual.
Attributes affected: Configuration event, LCB address in R11, and Supplementary
text message. The X.25 PSCS program product generates this CENLOG. Procedure:
PDNIUS.
7436 0728–303 5–89