DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
IP 14013: SMP initialization process started.
Description: Informational only.
Action: None.
IP 14015: SMP started
Description: Informational only.
Action: None.
IP 14016: SMP Unable to create IPSMP process
Description: The IP SMP component will not function.
Action: Standard action.
IP 14021: SMP Invalid domain on deregistration. Domain=&
Description: The IP manager has called the IP SMP component during down or
delete router processing but provided an unknown domain (&) identifier. The impact
of this error on system functionality may vary since the router is going down anyway.
& is the domain parameter value specified on the [SNMP] section header.
Action: Standard action.
IP 17621: UDP appl dg dscd. rtr=& err=&1
Description: The UDP component has discarded a UDP datagram it received from a
UDP service user, but was unable to pass to the IP component. &1 is a decimal
internal error code. You can use the NMS LOGI OPTN=LONG command to display
the discarded datagram. Probable service user software error.
Action: Standard action.
IP 17622: UDP IP dg dscd. rtr=& err=&1
Description: The UDP component has discarded an undeliverable UDP datagram it
received from the IP component (UDP datagrams that result in an ICMP Destination
Unreachable, Port Unreachable error message are not discarded and do not trigger
this event). &1 is a decimal internal error code. You can use the NMS LOGI
OPTN=LONG command to display the discarded datagram. Probable service user
software error if this event occurs when UDP logging and tracing is disable (OFF);
probable datagram checksum error if UDP tracing or logging level MED or HIGH is
enabled.
Action: Standard action.
13–22 7436 0728–303