DCP Series Telcon Message Manual - Public Support Login - Unisys

IP: CLEAR COLLISION: CAUSE = #, DIAG = #
Event 12 TCP–IP GATEWAY EVENT
Description: IP received a clear indication on a virtual circuit that was expecting a
clear confirmation. The TCP–IP program product generates this CENLOG.
IP: CONFIG ACCESS ERR: DLCUNIT PROCESSING
Description: IP cannot read a DLCUNIT configuration statement. IP detected an
internal error. This may indicate a serious software fault. The TCP–IP Stack program
product generates this CENLOG.
IP: CONFIG ACCESS ERR IN SAP PROCESSING
Description: IP cannot read a SAP configuration statement. IP detected an internal
error. This may indicate a serious software fault. The TCP–IP Stack program product
generates this CENLOG.
IP: CONFIG CONFLICT LOCAL ADDRESS = !
Description: A configuration error was detected. The IPADR statement specifying
the indicated IP address may be in error. There is no matching IP address in the ENS
IP Router configuration. Some configuration functions may not be available. The
TCP–IP Stack program product generates this CENLOG.
IP: CONFIGURATION ERROR,
RESTART TELCON FOR ONLINE CONFIGURATION CHANGES
Description: IP detected configuration errors. Internal tables do not match
configuration information. This error can occur when online configuration changes
are made. The
TCP–IP Stack program product generates this CENLOG.
IP: DGSIZE REDUCED FROM n TO n BYTES BY LINE linename
Description: Possible configuration error. Compare datagram size in SUBNET
statement with maximum datagram size permitted by line module.
IP: DIFFERENT SUBNET TYPES W/SAME NET: !
Description: IP found more than one SUBNET configuration, each with a different
TYPE parameter. The TCP–IP Stack program product generates this CENLOG.
IP: DLCUNIT CONFIG ERROR: STE = #
Description: DLCUNIT facility identifier is invalid. This error can occur when online
configuration changes are made. The TCP–IP Stack program product generates this
CENLOG.
7436 0728–303 3–35