DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 8 QUEUE ACCESS / ADDITION ERROR
SNA: 679 – ‘CPA$AQL’ failed: Error code = %%%%, Queue Num =
%%%%
Description: This message occurs when the DCP/OS is unable to successfully add a
que to the calling procedure’s queue list. The % represents a hexadecimal number.
SNA: 1005 – Queue list manipulation error
Description: This new boundary function (NBF) handles all of the management
messages for 3270 connected devices, IBF connections to NCPs, and connections to
NT 2.1 devices. The probable cause is a software problem.
TSTN
Description: SYSTSTRK or UDLC ask to put QCT indexes into TSTN’s queue list;
however, TSTN’s queue list is full; not enough space reserved. Command disregarded;
no queue added to queue list. Telcon generates this CENLOG.
X.25: Memory Too Low For PDNTRK To Add Queues
Description: The DCP-to-DCP module (PDNTRK) was unable to successfully expand
its queue list in order to add DNS’s output queues. The reason is probably because of
insufficient buffer space. The PDNTRK module pauses and attempts to expand its
queue list again at three second intervals until successful.
Attributes affected: Supplementary text message, recoverable error. The X.25
PSCS program product generates this CENLOG. Procedure: PDNTRK.
X.25: Up/Down Line Error in MLP Procedure
Description: An error occurred in one of the following DCPOS service calls:
CPA$AQL, CPA$DQUE, CPA$GQN, OR CPA$RQL.
R8: The nth PDNGRP statement specified in the configuration
R9: DCPOS error code
R14: Port Processor Identifier (PPID)
Attributes affected: line event, and configuration event. The X.25 PSCS program
product generates this CENLOG. Procedure: PDNMLP.
5–26 7436 0728–303