DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 8 QUEUE ACCESS / ADDITION ERROR
Event 8 QUEUE ACCESS / ADDITION ERROR
QUEUE ACCESS / ADDITION ERROR
Description: A procedure was not able to put a new message on a queue because the
queue was already full. This event occurred partly because the procedure was not
able to dynamically add a queue to the operational environment. Telcon generates
this CENLOG.
Action: No operator action is necessary. Program recovery paths were invoked
automatically.
NTRV2R
Description: This event occurs if NTRV2R either cannot get an available Q-list index
for an NTR site during sign-on processing, or if NTRV2R cannot delete a site’s console
queue during sign-off processing. This error is fatal to NTRV2R, resulting in the
procedure being blocked or in Telcon crashing. Other information is logged in the
registers, but applicable to debug only. Telcon generates this CENLOG.
RMVTR
RTC
Description: RMVTR detected an error in one of its queues.
R9: Stack pointer
R10: Source message buffer header
R11: Source message byte pointer
R12: TCB address
R13: Last subroutine call
R14: Varies
R15: Varies
Telcon generates this CENLOG.
Description: A queue access violation occurred while the user was trying to register
the priority trunk queues with route control. Telcon generates this CENLOG.
SNA: 608 – Output queue selected by CQM (G,A)
Description: This message occurs as a result of errors or events in the crossover
application bridge (XAB). The XAB handles traffic between SNA resources and OS
2200 hosts. The probable cause is a software problem.
7436 0728–303 5–25