DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 12 TCP–IP GATEWAY EVENT
2007 TELNET NO ULP ID GIVEN
Description: A message was received from the LLP that did not specify a ULP
connection ID. The TCP–IP Stack program product generates this CENLOG.
2008 TELNET INVALID ULP ID GIVEN
Description: A message was received from the LLP that specified an invalid ULP
connection ID. The TCP–IP Stack program product generates this CENLOG.
2009 TELNET INVALID LLP ID GIVEN
Description: A message was received from the ULP that specified an invalid LLP
connection ID. The TCP–IP Stack program product generates this CENLOG.
2010 TELNET NO CONN TABLE EXISTS
Description: A message was received that specified a nonexistent connection entry.
The TCP–IP Stack program product generates this CENLOG.
2011 TELNET BAD PKT RECEIVED
Description: An error was detected within the interface packet. The TCP–IP Stack
program product generates this CENLOG.
2012 TELNET INVALID QUEUE ID RECEIVED
Description: A message was received from a protocol module that is currently not
supported by the TELNET module. The TCP–IP Stack program product generates this
CENLOG.
2013 TELNET BAD PACKET RETURNED
Description: TCP–IP Stack detected an error in the interface to another software
component. This condition is normally recoverable. The TCP–IP Stack program
product generates this CENLOG.
Action: If the condition persists, contact your support center.
2014 TELNET INVALID CONN ATTEMPT
Description: Software error (warning). The data-link control manager service
module that maintains the interfaces to the link providers generates this CENLOG. A
host program (USER) did not supply a %%CONNECT command as the first data
transfer to the DDN Gateway. The TELNET module generates this CENLOG.
3–66 7436 0728–303