DCP Series Telcon Message Manual - Public Support Login - Unisys

NMS and DSA Messages
*** ERROR: INSPECT LENGTH EXCEEDED ***
Description: The LENGTH parameter for the INSP command is too large.
Action: Reenter it with a value of 128 or less.
*** ERROR: INVALID PARAMETER ARGUMENT ***
Description: The number used to specify a facility is out of range. This is an X.25
PSCS message.
*** ERROR: INVALID PARAMETER VALUE ***
Description: The value associated with a parameter is not correct.
Action: Check the command syntax, and reenter the command.
*** ERROR: INVALID POLL GROUP NUMBER ***
Description: The poll group remote identifier (RID) does not exist with the line
specified in the command statement.
Action: Check the configuration for the correct poll group RID, and reenter the
command.
*** ERROR: INVALID STANDBY DCP ID ***
Description: The FOR parameter value in ONLN or STBY command should be a
backup Telcon node.
Action: Correct the value, and retry the command.
*** ERROR: INVALID X.25 COMMAND ***
Description: Input is not a valid X.25 command. This is an X.25 PSCS message.
*** ERROR: IO VALUE INVALID ***
Description: The I/O value is incorrect.
Action: Change the appropriate value, and reenter the command.
*** ERROR: KEYWORD NAME TOO LONG ***
Description: The command keyword name is too long.
Action: Make the appropriate change and reenter the command, or use HELP.
17–12 7436 0728–303