DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 11 ILM EVENT
LAPBHS (045): OLD station configuration OVER-WRITTEN by NEW
Description: There is more than one station configured for a line. Only the last
station configuration packet is honored. This CENLOG also can indicate a second
attempt to bring up a station.
Action: Check the Telcon configuration and correct if necessary.
LAPBHS (046): Output message of invalid length Discarded
Description: There was an output attempt of a message larger than the configured
maximum I-frame size. The message was discarded.
Action: Correct the Telcon configuration.
LAPBHS (047): Up Station FAILED - no UDM queue
Description: This is a software error.
Action: Contact your Unisys representative.
LAPBHS (048): Up Station FAILED - no input data queue
Description: This is a software error.
Action: Contact your Unisys representative.
LAPBHS (049): Indication packet REJECTED by ILM platform
Description: This is a software error.
Action: Contact your Unisys representative.
LAPBHS (050): Return of ATTACH/DETACH packet rejected
Description: This is a software error.
Action: Contact your Unisys representative.
LAPBHS (051): XPC driver error - illegal command
Description: This is a software error. The hardware driver issued an invalid
command or a valid command at a time when that command is not allowed.
Action: The software will attempt recovery. An ILM DUMP may indicate the cause
of the failure. Contact your Unisys representative.
6–76 7436 0728–303