DCP Series Telcon Message Manual - Public Support Login - Unisys

TCP 4012 ULP–REQUESTED CLOSE OCCURRED
Event 12 TCP–IP GATEWAY EVENT
Description: The local end user terminal or application closed or aborted the TCP
session. Try again. The transmission control protocol module for the TCP–IP Stack
program product generates this CENLOG.
TCP 4013 TIMEOUT OCCURRED
Description: TCP encountered the maximum number of message timeout
occurrences. The transmission control protocol module for the TCP–IP Stack
program product generates this CENLOG.
TCP 4014 OPEN FAILURE
Description: TCP is unable to complete a connection opened by a ULP. The
transmission control protocol module for the TCP–IP Stack program product
generates this CENLOG.
TCP 4015 INTERNAL ERROR
Description: Local TCP internal error. The transmission control protocol module for
the TCP–IP Stack program product generates this CENLOG.
TCP 4016 DCPOS CANNOT ALLOCATE ANY MORE DSSNs
Description: This message indicates a resource shortage. It usually is a sign of
insufficient memory for the size of Telcon or the number of Telcon runs. The
transmission control protocol module for the TCP–IP Stack program product
generates this CENLOG.
TCP 4017 NMS REQUEST ABORT
Description: TCP–IP Stack is closing a TCP session in response to the NMS
command TCP KILL TCP. This message is informational only. The TCP–IP Stack
program product generates this CENLOG.
TCP 4018 RECEIVED UNRECOGNIZED NMS COMMAND
Description: TCP–IP Stack detected an error in the interface to another software
component. This condition is normally recoverable. The TCP–IP Stack program
product generates this CENLOG.
Action: If this condition persists, contact your support center.
7436 0728–303 3–57