DCP Series Telcon Message Manual - Public Support Login - Unisys

IP: LAN ATTACHMENTS INCOMPLETE (R8=STE)
Event 12 TCP–IP GATEWAY EVENT
Description: IP detected a missing DLCUNIT or SAP statement. The TCP–IP Stack
program product generates this CENLOG.
IP: LAN SUBNETS SHOULD SPECIFY LINES
Description: IP found a SUBNET configuration of TYPE=LAN, LANLLC, IPTR, or
FDDI, which does not reference a LINE. The TCP–IP Stack program product
generates this CENLOG.
IP: LINK AREA IS FULL
Description: IP has tried to save data for later processing. Because of an acute
resource shortage, the data was not saved. The TCP–IP Stack program product
generates this CENLOG.
IP: LINK AREA OVERFLOW
Description: A moderately serious problem that could be caused by an acute
problem. The link area has a large capacity, and link-area overflow means hundreds
of messages and fragments of messages have not been processed. If the problem
persists, dump and restart Telcon. The TCP–IP Stack program product generates this
CENLOG.
IP: LINK AREA WAS NOT EXPANDED
Description: A shortage of memory resources. The link area space currently
allocated is insufficient to meet message storage requirements, so the latest input will
probably be discarded. This problem is likely to occur before link-area overflow
occurs. The TCP–IP Stack program product generates this CENLOG.
IP: LOGICAL HOST ENABLED: CAUSE = #, DIAG = #
Description: A configured logical host has been enabled. The TCP–IP Stack
program product generates this CENLOG.
IP: LOGICAL HOST NOT ENABLED: CAUSE = #, DIAG = #
Description: A configured logical host could not be enabled. R8 contains a
diagnostic code. The TCP–IP Stack program product generates this CENLOG.
IP: MAP FOR IP ADDRESS ! DOESNT MATCH NETWORK !
Description: TCP–IP Stack detected a configuration error. The address mapping
using the DTE, NA, or STA parameter on an IPADR statement does not match the
7436 0728–303 3–43