DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 11 ILM EVENT
LAPBHS (023): STATION CONFIG ERROR, Must be Async Balanced
Mode
Description: The station is not configured in async balanced mode.
Action: Correct the station configuration for async balanced mode.
LAPBHS (024): STATION CONFIG ERROR, Local Station Must be ABM
Description: The station is not configured as async balanced mode.
Action: Correct the station configuration for async balanced mode.
LAPBHS (025): Line UP
Description: The data-set-ready signal was received.
Action: None, this message is informational only.
LAPBHS (026): Line DOWN
Description: The data-set-ready signal was lost.
Action: None, this message is informational only.
LAPBHS (027): Station Entered Information Transfer State (ITS)
Description: The SABM/UA exchange was successful.
Action: None, this message is informational only.
LAPBHS (028): Station Entered Logical Disconnect State (LDS)
Description: DISC/UA was successful or fatal protocol error occurred.
Action: Check the line error counter using the following ILM mode NMS command:
DISP PORT pp LINE I TYPE ERRS. This command identifies error conditions that
may have caused the disconnect. If the line continues to toggle between ITS and LDS,
check the value of the T1 timer using the following ILM mode NMS commands: LIST
LINE line_name or LIST LINE pp/l. If the T1 timer is not long enough, it may be
lengthened in your TELCON configuration by adding or lengthening the response
timer.
7436 0728–303 6–73