DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 12 MESSAGE PROCESSING ERROR DETECTED
SNA: 2651 – Unsupported MUCB signal (%%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2652 – Unsupported SC request (%%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2653 – Unsupported DFC request (%%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2654 – Unsupported RU category (%%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2658 – Received device status - %%%%
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2659 –Session Request - REJECTED - FROM=@@@@@@@@
TO=@@@@@@@@
Description: The POOL configured limit of dynamically allocated LUs - SESLIM - has
been exceeded. The @ represents LU names.
• Reconfigure another value higher on the specific POOL statement and reset the
POOL using NMS DOWN/UP.
• A PARTNER/terminal has attempted to connect to its configured static LU but the
LU is marked as DOWN. The PARTNER/terminal connection using the EPU2
POOL is not usable until the LU is set to an UP state.
UNABLE TO ADD DYNAMIC QUEUE TO QUEUE LIST
Description: The dynamic queue could not be added to the queue list of NMSIS as
part of a command register. Telcon generates this CENLOG.
Action: Submit a User Communication Form (UCF) with a system dump.
5–56 7436 0728–303