DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
OSISIS: GPTS ERROR: tmr_dereg(ISH)
Description: An error occurred trying to stop the ISH timer. The OSISIS component
of the OSITS program product generates this CENLOG.
Reason:
R8: Memory management error code
R9: System error code
R10: Gpts error code
OSISIS: ID FIELD LENGTH MISMATCH
Description: Received an ISIS PDU with an ID length that does not match the
SYSIDLEN configured on the NSAP configuration statement. The OSISIS component
of the OSITS program product generates this CENLOG.
Reason: There is an IS on the network that is not configured correctly.
OSISIS: IGNORING UNRECOGNIZED OPTION IN ISIS PDU
Description: An ISIS PDU was received with an unknown option. The OSISIS
component of the OSITS program product generates this CENLOG.
Reason: There is an IS on the network sending invalid or experimental PDUs.
OSISIS: INITIALIZATION FAILURE (AREA MISMATCH)
Description: Received an IIH that had no area addresses in common. The OSISIS
component of the OSITS program product generates this CENLOG.
Reason: There is an IS on the network that is in a different Level 1 area or not
configured correctly.
OSISIS: INVALID ADJ IN TENT
Description: The adjacency ID stored in the tentative paths pool could not be
brought into visibility. The OSISIS component of the OSITS program product
generates this CENLOG.
Reason: Programming error.
OSISIS: INVALID CIRCID IN ADJACENCY POOL
Description: Could not bring circuit ID into visibility. The OSISIS component of the
OSITS program product generates this CENLOG.
Reason: Programming error.
13–46 7436 0728–303