DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 8 SYSTEM SERVICE CALL EXCEPTION STATUS
Unable To Delete X.25 System Segment
Description: The X.25 line termination module (PDNSVS) was unable to successfully
complete the disabling of an X.25 line. One or more dynamic system segments
chained from the Line Control Block (LCB) could not be deleted. This event includes
the LINE name.
Attributes affected: Line event, Recoverable error event, Line Control Block (LCB)
address in register
R11: The X.25 PSCS program product generates this CENLOG.
Procedure: PDNSVS
UNABLE TO RE-INIT PORT AFTER STATE ITEM
Description: The X.25 line services module (PDNSVS) was unable to successfully restart
the port processor after receiving a port processor state- item notification.
PDNSVS could not create and add queues for this port processor. This event includes
the LINE name.
Attributes affected: Supplementary text message, Line event, Error event. The
X.25 PSCS program product generates this CENLOG.
Procedure: PDNSVS
UDLCRS
Description: The line is disconnected; however, because of an error in accessing the
line information table, the line is hung until a network administrator brings it down
R8: 0036. AE$UD160. (UDLC): LINE DISC FAILURE: CONFIG LINE READ ERR.
DOWN/UP THE LINE
R9: Most recent NAK-1 detail code
R10: Active device counts word from SCT
R11: LCB/SCT address
R12: NS$STAT1 word from SCT (status flags)
R13: NS$STAT2 word from SCT (more status flags)
R14: LINE-ID
Telcon generates this CENLOG.
12–10 7436 0728–303