DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 15 CONFIGURATION ERROR DETECTED / UNDEFINED
ILMX25 Waiting for Response From ILM Platform
Description: The PDNILM module has not received a response from a request packet
that it previously sent to the ILM Platform.
Attributes affected: Line event includes the port number and supplementary text
message. Procedure wait_receive of the X.25 PSCS program product generates this
CENLOG.
Action: If the line was not previously enabled then the ILM Platform may not be
responding because required ILM load and configuration files are not present on the
DCP mass storage. The ILM-20 HS omnibus load file element, ILMLOAD.ILMPLATA1,
must be present. The ILM-20 HS source configuration file element,
ILMCFG.PSCSHDLC, must also be present. The qualifier name for these files must
match the project id of the DCP OS Run statement used to start the Telcon program.
If the line was previously active then this event may indicate a (severe) looping or
hanging condition in the ILM Platform or ILM IA.
ILMX25 Line Already Down
Description: PDNILM received an NMS DOWN LINE request from the ILM Platform,
but the indicated line is already marked down in the configuration, or no line control
block (LCB) is associated with the line.
Attributes affected: Line event includes the port number and supplementary text
message. Procedure p_nms_dwn of the X.25 PSCS program product generates this
CENLOG.
Action: Check the Telcon configuration for duplicate port addresses on the LINE
configuration statement’s ADR parameter.
Initialization error (Error code = %%%%)
Description: This message occurs as a result of errors or events in the crossover
application bridge (XAB). The XAB handles traffic between SNA resources and OS
2200 hosts. The probable cause is resource availability (out of memory, out of disk).
SNA/net message number 600.
Possible values for initialization errors are as follows:
• Unable to load PST
• SVC$CSEG unable to create SSN for common data segment
• SVC$CSEG unable to create SSN for element address index table
• SVC$CSEG unable to create SSN for host table
LPHTRS
Description: TRS was notified of a CFACCS error status software error report by file
control. Telcon generates this CENLOG.
7436 0728–303 5–77