DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 8 RESILIENT MOVE COMPLETION
Event 8 RESILIENT MOVE COMPLETION
Resilient Move Completion: Good/Bad
Description: This CENLOG provides information about the outcome of a resilient
move from a line to a spare line. A resilient move can be initiated by either the SRC
detecting a PP State Item or an operator performing an RMOV command on an NMS
console. If the resilient move completion status is bad, the line will be inoperative.
This could be caused by another line using the spare port, even though it is not
configured to use the spare line.
Action: In this case, check the configuration for port conflicts. Otherwise, check all
applicable hardware and repair or replace as necessary.
11–12 7436 0728–303