DCP Series Telcon Message Manual - Public Support Login - Unisys

X.25 PSCS Diagnostic Codes
Table A–1. X.25 Diagnostic Codes
Code Diagnostic Source
Dec Hex
51 33 Time expired for reset indication PDN, PSCS, DAD generated
52 34 Time expired for restart indication PDN, PSCS, DAD generated
53 35 Time expired for call deflection PDN, PSCS, DAD generated
64 40 Call set up, call clearing, or
registration problem
64 40 An incoming call packet was received
for the TCP–IP Stack, but didn’t
contain the required protocol ID
information in the call user data field.
64 40 An incoming call packet contains a
badly formatted facility field
parameter.
64 40 No available resources for handling a
new virtual circuit connection.
64 40 An incoming call packet was received
for the X.29 PAD handler, but didn’t
contain the required protocol ID
information in the call user data field.
64 40 For the X.29 PAD handler, a $$SON
error occurred.
64 40 An incoming call packet was received
for the DCP-to-DCP Trunk handler, but
the X.25 Trunk is not initialized or not
configured.
64 40 An incoming call was received for the
following program products or
features, but they are not installed,
configured, or initialized: OSITS
program product, TCP–IP Stack
program product, DCE Networking
Feature, or the user-written layer 4s
for handling international, national, or
user-defined protocol IDs.
64 40 An incoming call packet was received
for the X.28 PAD Terminal handler.
This interface is not designed to
receive incoming call packets.
PDN, PSCS, DAD generated
PSCS generated
PSCS generated
PSCS generated
PSCS generated
PSCS generated
PSCS generated
PSCS generated
PSCS generated
65 41 Facility/registration code not allowed PDN, PSCS, DAD generated
A–4 7436 0728–303