DCP Series Telcon Message Manual - Public Support Login - Unisys

COMMAND REJECTED: SWITCH ALREADY IN PROGRESS
NMS and DSA Messages
Description: Previous SWT, ONLN, or STBY command has not been completed yet.
Action: Wait for SWITCH COMPLETE message, and retry the command.
DEVICE NAME...
DEVICE NAME: aaa DEVICE TYPE: aaa
DEVICE STATUS: aaa IOP NUMBER: a
PPID NUMBER: n UNIT NUMBER: n
VOLUME MOUNTED: n PAIRED DEVICE NAME: aaa
Description: This is a STAT DEVICE command response.
DIAL ON PORT XXX, DCP XXXXXXXX, PHONE # X...X
Description: This is the manual dial-up message.
Action: Perform a dial-out function on the port specified to the telephone number
specified.
Additional Information: When a system session open request is received from a
host for a terminal that is attached to an inactive group, an attempt is made to
establish the physical connection with the terminal using an auto or manual dial-out
operation. An auto-dial operation involves a second port processor, which is cabled to
an automatic call unit connected to a local modem. It requires a special line module
to perform the dial function. The operation is performed with hardware and software
and requires no human intervention. Manual dialing involves a Telcon node operator
performing the dial operation to the specified group of terminals from the local
modem attached to the indicated port processor. The Telcon node always attempts
first to locate an auto-dial line; if it fails to locate one, it attempts a manual dial-up
operation.
This message and the one following are used to communicate with the Telcon node
console operator during dial-out attempts.
DIAL TIMEOUT ON PORT XXX, DCP XXXXXXXX. PLEASE PLACE
PHONE ON HOOK
Description: This is the manual dial-up message.
Action: Place the phone on the hook to terminate the manual dial-out operation.
7436 0728–303 17–5