DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 9 INVALID RUN TIME TABLE ACCESS
Event 9 INVALID RUN TIME TABLE ACCESS
INVALID RUN TIME TABLE ACCESS
BAD CENLOG HEADER: INVALID LENGTH (2 nd from R12)
R8-R15= 80000 E000 C800 2EFB E010 0070 F000 0002
DTP
DTP
IPC
Description: A procedure detected an illegal or invalid reference to an operational
table that may not exist. An example of this is the access of a terminal control block
table that has been removed by normal sign-on/sign-off processing. These “timing
windows” occur in large network operations. Telcon generates this CENLOG.
Action: Depending on the frequency and the severity of the impact, submit a UCF
with a system dump.
Description: DTP is unable to load the TP$ (transport connection) table or the TN$
(network connection) table. R12 = TN$ table address (for example, X'B004') unless
otherwise specified. Unable to load TP$ table: Input received with bad BH$ID1 and
BH$ID2. The pace literal is invalid (R12 = 0). Unable to load TN$ table: Cannot find a
suitable network connection (TN$) table for a CDATA (connectionless data) request.
Telcon generates this CENLOG.
Description: The segment not loaded. The PST load (SUSPST) for the TN$ table
failed (R12 = X'FFFF' or R12 = 4 ). The PST index is out of range for the TN$ table
(R12 = 1). The TN$ entry number is out of range (R12 = 2). There is an insufficient
number of slots for TN$ segments in DTP PST (R12 = 6). The analyst should check
the configuration, especially for SESSN statements defined or defaulted by DTP.
Telcon generates this CENLOG.
Description: An attempt was made to access an IPC context area that was not
supporting any conversation. Telcon generates this CENLOG.
LMS
Description: LMS received an invalid DLU or MDL service access point across the
LMS interface. Telcon generates this CENLOG.
NO LCB TO INITIALIZE LINE STATISTICS TABLE
Description: LCB is nonexistent, although it was requested by the LPH to count I/O
statistics by way of the LOGSTAT procedure. An LPH could have passed an invalid
PPID to the LOGSTAT procedure. Telcon generates this CENLOG.
7436 0728–303 5–27