DCP Series Telcon Message Manual - Public Support Login - Unisys

Remote File System (RFS) Messages
Table 18–2. Messages Defined by DDP
DDP
Status
Code Message Explanation (for Telcon systems)
130 FILE NAME ALREADY EXISTS An attempt was made to create a file with a
name that already exists (the file may exist on
disk, or may be assigned as a tape file).
131 VOLUME SPACE NOT
AVAILABLE
132 VOLUME NAME NOT
AVAILABLE
133 SOURCE VOLUME NOT
AVAILABLE
There is not enough space to create the file on
the target system; there is not enough space
to create the file on the requested device or
volume; or the file catalog is full.
The volume is not available; the volume is a
system read-only volume; or the file resides on
a volume that is not available.
The file resides on a volume that is not
available.
134 FILE TYPE NOT SUPPORTED The file type is not SEQUENTIAL or
UNDEFINED; or an element type parameter is
specified.
135 INVALID KEY SPECIFICATION A file key is specified.
136 INVALID FILE SIZE
SPECIFICATION
140 DEVICE CLASS/TYPE NOT
AVAILABLE
141 DEVICE CLASS/TYPE NOT
SUPPORTED
The maximum size parameter is greater than
65,535 blocks.
The device class or device type is down; or
there are no tape drives that are up.
The device class is not DISK, DISKETTE, or
TAPE; the device type is not FIXED, REMOVE,
WINCH, or 8441W for device-class DISK; the
device type is not FDDS, FDS, IFDC, or 8441D
for device-class DISKETTE; or no tape drives
are configured.
142 FILE NAME SYNTAX ERROR The file name has an invalid length; the file
qualifier has a invalid length; or the file system
detected an invalid file name.
160 SOURCE FILE NOT FOUND The file does not exist on the target system.
161 SOURCE ELEMENT TYPE
NOT SUPPORTED
162 ELEMENT NAME NOT
FOUND
163 SOURCE FILE NOT
AVAILABLE
165 READ KEY INVALID OR
MISSING
Not applicable to Telcon.
Not applicable to Telcon.
The file is in use, and the mode parameter is
not WAIT.
Not applicable to Telcon.
18–4 7436 0728–303