DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 3 CP QUEUE FULL CONDITION
RMLPH
Description: The design of RMLPH makes the overflow of the queues from RMLPH
to RMIOP impossible.
R9: I/O state
R10: Message address
R11: LCB address
R12: TCB address
R14: PP ID
Telcon generates this CENLOG.
SNA: 810 – msg not sent to tg; psa, pea, yea = %%%% %%%%
%%%%
Description: This message occurs as a result of errors in Path Control (ERVR), the
network routing portion of SNA/net. The psa refers to partner subarea, pea refers to
partner element address, yea refers to your element address, and % represents a
hexadecimal number. The probable cause is a software problem.
SNA: 1800 – Pascal Send Failed
SRC
SRC
TAF
Description: This message occurs as a result of errors in SNMS, the part of SNA/net
that processes operator commands. The probable cause is a software problem.
Description: SRC has received a TS down message from HCC through CENLOG.
The TSID is saved on a dynamic queue so that a pause can be effected to allow the
alternate DCP to send a host status command. The dynamic queue has overflowed.
The message is discarded and no resilient switch is affected. Telcon generates this
CENLOG.
Description: SRC is attempting to send a message to the console in response to an
NMS command. The NMS queue is full and the dynamic save queue is full. The
response is discarded. Telcon generates this CENLOG.
Description: A queue to which a caller must send an item is full, mandating a timed
suspension. Telcon generates this CENLOG.
5–4 7436 0728–303