DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
X.25: PDNL3 TRACE FILE ERROR
Description: The PDNL3 module was unable to successfully write trace information
into its trace file. An error was returned by the DCP OS FILE$ service.
R8: DCP OS FILE$ error code
Attributes affected: Supplementary text message. The X.25 PSCS program product
generates this CENLOG. Procedure: PDNL3.
X.25 - PDNL3 Trace File Error - No Space
Description: The NMS TRAC SNAP=X25 command was used to enable an X.25
protocol packet and/or message data tracing on a virtual circuit. An error occurred
while cataloging the trace file used by the PDNL3 module.
R8: DCP/OS FILE$ error code corresponding to equate FR$NS, “no space or no
free DSL”
Attributes affected: Supplementary text message. The X.25 PSCS program product
generates this CENLOG. Procedure PDNL3.
Action: Delete some unused DCP mass storage files to free disk space. The disk
space required must be contiguous.
X.25 Reset by DCP–Cause, Diagnostic=hhhh,hhhh
Description: The Common Network Management Service (CNMS) X.25 interface
module in PDNSVS received an alarm notification. (CNMS does not need to be
operating for this CENLOG to be enabled.) The layer 3 module sent a reset packet to
the network for a particular virtual circuit. This event may include the DTE statement
name or address information.
R8: PDNGRP STE index
R9: Logical channel number
R10: Packet’s cause code. See Appendix C of this manual for a description of the
cause code.
R11: Packet’s diagnostic code. See Appendix A of this manual for a description of
the diagnostic code.
R12: CNMS alarm code
Attributes affected: Supplementary text message, Line event, Device event (if the
clear [reset] packet is associated with a configured DTE statement and CNMS is not
active), can include CNMS interface packet. The X.25 PSCS program product
generates this CENLOG. Procedure: PDNSVS.
13–66 7436 0728–303