DCP Series Telcon Message Manual - Public Support Login - Unisys

DTE VC WASNT LOADED
Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
Description: The PDNDXA module received an NMS DOWN PDTE indication
primitive, but was unable to associate a DTE virtual circuit table based upon the DTE
address passed by the primitive. A software error has corrupted the DTE address
passed in the primitive.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
DTETS TBL NOT BUILT
Description: The PDNDXA module was unable to successfully build a DTE TS table
entry using information obtained from the DCATS statement. A software error has
either corrupted the DCATS STE or the routine that builds DTE TS tables.
Attributes affected: Error event, Configuration event. The X.25 PSCS program
product generates this CENLOG. Procedure: TPCDATA.
DTEVC HAS NO LSCH LIST
Description: The PDNDXA module cannot successfully associate one of its DTE
virtual circuit tables with a logical subchannel table entry. A software error has
corrupted the logical subchannel table entry addresses within the DTE virtual circuit
tables.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
INVALID DTETS LOG ADR
Description: The PDNDXA module was unable to associate one of its TSID table
entries from an address obtained from its DTE virtual circuit table. A software error
has corrupted the TSID address in the DTE virtual circuit table.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
INVALID DTEVC LOG ADR
Description: The PDNDXA module cannot obtain the DTE VC table entry using an
address from the logical subchannel table entry. A software error has corrupted one
of the DTE VC table entry addresses in one of the logical subchannel table entries.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
7436 0728–303 13–13