DCP Series Telcon Message Manual - Public Support Login - Unisys

X.25 PSCS Initialization Error Codes
Code
(Hex)
Table B–1. X.25 PSCS Initialization Error Codes
Explanation
2005 An invalid logical channel number is specified for a VCGRP keyword on a
PDNGRP statement. The last logical channel number must be greater than or
equal to the first logical channel number. Initialization has been completed, but
the VCGRP parameter was ignored. Register R10 contains the STE index of
the PDNGRP statement on which the error occurred.
2006 An unknown virtual circuit type is specified for a VCGRP keyword on a PDNGRP
statement. Initialization has been completed, but the VCGRP parameter was
ignored. Register R10 contains the STE index of the PDNGRP statement on
which the error occurred.
2007 A configuration access (CFACCS) read error has occurred. Register 10 (R10)
contains the CFACCS error code (SB$CAERR).
2008 A configuration access (CFACCS) write error occurred. Initialization is
complete; however, register 10 (R10) contains the CFACCS error code
(SB$CAERR). Register 12 (R12) contains the STE index of the table being
updated.
2009 Maximum number of DTE statements has been exceeded.
200A The ABBRVADR option was specified on a DTE statement that references a
DTETYPE statement defining a Level 4 parameter of PDNTRUNK, PDNDXA,
PDNUNIX, PDNX28, or PLS. This is not a valid configuration. Initialization has
been completed, but the ABBRVADR option was ignored on the DTE statement.
200B A DTE statement references a TRUNK statement that is also being referenced
by another compatible network service such as a LAN link (SAP statement).
2100 The logical channel range specified on the DTE statement PERMVC parameter
is not within the logical channel range specified on the VCGRP parameter on
the PDNGRP statement that functions as the DTE statement’s parent.
4000 There is no one-to-one correspondence between LINE and PDNGRP statements.
Either no LINE statement or more than one LINE statement references a
PDNGRP statement.
B–2 7436 0728–303