DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 15 CONFIGURATION ERROR DETECTED / UNDEFINED
SYSSESN
Description: Error on SESSN card — fatal.
R14: Indicates type of error
= 1 – Session length long, check TS1/TS2
= 2 – Session length short, check TS1/TS2
= 3 – CFACCS error return while building LX$ table
= 4 – Bad Telcon node destination, check TS1/TS2
= 7 – Duplicate logical subchannel
R15: LS #
Telcon generates this CENLOG.
Too many digits on the PDNGRP DTEADR parameter
Description: During line initialization (module PDNSVS) obtained the PDNGRP
statement associated with the LINE statement that was enabled. The number of DTE
address digits configured on the PDNGRP’s DTEADR parameter is greater than 14.
The DTE address specified is ignored. This event includes the LINE statement name.
R10: PDNGRP STE index
Attributes affected: Supplementary text message, Configuration event. The X.25
PSCS program product generates this CENLOG. Procedure: PDNSVS.
TOO MANY SESSIONS CONFIGURED–INCREASE AC$SESSS.
Description: This CENLOG refers to an error in TS/TN where it received an
initialization for a SESSN that was not put into the TS/TN SS$ table. This is because
the number of SESSNs configured was greater than the maximum table space
available. If none of the SESSNs to the termination system were able to get into the
SS$ tables, the user may have a problem getting into the termination system. The
default is currently 4000 SS$ entries. The system discards this message. Telcon
generates this CENLOG.
Action: Increase the value for AC$SESSS in AACONFIG by using the NEWCON
parameter.
TSTN
Description: Fast path protocol has been specified in Telcon, but the host does not
support it. This problem could cause Telcon to run in a loop. Check the host system
release to make sure the host supports fast path protocol. Telcon generates this
CENLOG.
5–86 7436 0728–303