DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 12 TCP–IP GATEWAY EVENT
IPSVS: PK$ ERROR FROM IP
Description: TCP–IP stack detected an internal error. This could indicate a serious
software fault. The TCP–IP Stack program product generates this CENLOG.
IPSVS: UNKNOWN IP MESSAGE TYPE
Description: TCP–IP stack detected an internal error. This could indicate a serious
software fault. The TCP–IP Stack program product generates this CENLOG.
RIP: Cannot init configured route
Description: The interface configured on the SUBNET statement cannot be placed in
the RIP’s routing table because of insufficient memory. The routing information
protocol module for the TCP–IP Stack program product generates this CENLOG.
RIP: Cannot init static route
Description: RIP cannot place a static route into its routing table because of
insufficient memory. The routing information protocol module for the TCP–IP Stack
program product generates this CENLOG.
RIP: Invalid Subnet Mask on Subnet NDS
Description: TCP–IP Stack detected a configuration error. The SUBNMASK
parameter on a SUBNET statement is not correct. The TCP–IP Stack program
product generates this CENLOG.
Action: Verify the configuration to make sure all IP addresses are specified correctly.
RIP: Maximum number of IPADDRs exceeded
Description: TCP–IP Stack could not process all configuration statements
completely. Some configured functions may not be available. The TCP–IP Stack
program product generates this CENLOG.
RIP: Maximum number of RIPNBRs exceeded
Description: TCP–IP Stack could not process all configuration statements
completely. Some configured functions may not be available. The TCP–IP Stack
program product generates this CENLOG.
3–50 7436 0728–303