DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 13 PROCEDURE PROCESSING ERROR (INTERNAL)
SNA: 1035 – SETTIM request failed
Description: This message occurs as a result of errors or events in terminals
attached to SNA/net. The probable cause is a software problem.
SNA: 1037 – LU control block create error
Description: This message occurs as a result of errors or events in terminals
attached to SNA/net. The probable cause is a software problem.
SNA: 1038 – BFNPSI - Invalid control message
Description: This message occurs when an invalid control message is received by
the boundary function (BF) from the program product PSCS or from SNA/net module
NT21CP.
SNA: 1039 – BFNPSI - Invalid PUCB state = %%%%
Description: This message occurs when boundary function (BF) receives a PSCS
“call accept” message and the physical unit (PU) calling “type” was found to be
incorrectly configured. The % represents a hexadecimal number.
SNA: 1040 – BFNPSI - No PU found for rcv’d IDBlk/Num
(%%%%%%%%)
Description: This message indicates that an XID was received with a given
IDBLK/IDNUM and no PU was configured on the DTE with a matching
IDBLK/IDNUM. A PU needs to be configured with a matching IDBLK/IDNUM value
before it will connect. Optionally, only one PU with no IDBLK/IDNUM field can be
configured per DTE where no validation is performed. The % represents a
hexadecimal number.
SNA: 1041 – BFNPSI - PU with IDBlk/Num(%%%%%%%%) already
active
Description: This message indicates that a PU with a given IDBLK/IDNUM is already
active on the DTE and the new request is denied. This may be an inadvertent
duplicate of an XID’s use of the IDBLK/IDNUM. Remote configurations should be
investigated. The % represents a hexadecimal number.
SNA: 1409 – Msg discarded - SNMS to NMS internal sess bad
Description: This message occurs as a result of errors in SNMS, the part of SNA/net
that processes operator commands. The probable cause is a configuration problem.
7436 0728–303 5–63