DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)
LEVEL 4 ROUTING ID IS UNKNOWN TO LEVEL 3
Description: A layer 4 sent a call request primitive to layer 3 without including its
routing id.
R11: Diagnostic code. See Appendix A of this manual for more information.
Attributes affected: Supplementary text message. The X.25 PSCS program product
generates this CENLOG. Procedure: PCALL.
LOADED WRONG DTETS TBL
Description: The PDNDXA module cannot use one of its DTE TS table entries
because the entry addresses do not match. A software error has either corrupted the
entry address within the DTE TS table or the routine used to obtain a DTE TS table
entry has become corrupted.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
LOADED WRONG DTEVC TBL
Description: The PDNDXA module cannot use one of its DTE VC table entries
because the entry addresses do not match. A software error has either corrupted the
entry address within the DTE VC table or the routine used to obtain a DTE VC table
entry has become corrupted.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
LOADED WRONG LSCH LIST
Description: The PDNDXA module cannot successfully load one of its logical
subchannel table segments. A software error has corrupted the procedure segment
table.
Attributes affected: Error event. The X.25 PSCS program product generates this
CENLOG. Procedure: TPCDATA.
LSCH LIST CHAIN CORRUPTED
Description: The PDNDXA module was unable to remove all chained logical
subchannel table lists from one of its DTE VC table entries. A software error has
corrupted one of the logical subchannel table list chains.
Attributes affected: Fatal error event. The X.25 PSCS program product generates
this CENLOG. Procedure: TPCDATA.
13–32 7436 0728–303