DCP Series Telcon Message Manual - Public Support Login - Unisys

SNMP Messages
SNAUIA0 (072): Verify_msg: Input PIU not of Type 4
Event 11 ILM EVENT
Description: The SNA User Interface application received a message with an invalid
format header.
SNAUIA0 (073): Verify_msg: Input PIU Length Error
Description: The SNA User Interface application received a message with an invalid
length specification.
Note: All SNMP CENLOG messages include a name in parentheses at the end of
the message. This name is the name of the internal routine which produced
the CENLOG. The exact message, including this name must be included
with any report of a problem.
SNMP 101 Alt response PDU is too big
Description: An error response PDU was built to be sent to the SNMP management
station, but the PDU was too big to fit in the output buffer. The response is discarded.
Action: Single occurrences can be ignored. If this error occurs repeatedly, dump the
ILM to determine the cause of the problem.
Note: Some SNMP CENLOG messages have variable parts that may vary each
time the CENLOG is generated.
SNMP 102 ASN.1 construct not supported: ssssssss
Description: The SNMP Agent encountered an ASN.1 construct in a PDU from a
management station that it does not support. The message is discarded.
Variable: ssssssss The type of ASN.1 construct that is not supported.
Action: Single occurrences can be ignored. An SNMP trace with TYPE=M can be
used to capture the offending management PDU.
7436 0728–303 6–89