DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 13 PROCEDURE PROCESSING ERROR (INTERNAL)
SNA: 2607 – PC NRCB services error (Service Request
Code = %%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2626 – (PS) Invalid procedure call (Caller id = %%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2634 – BLDACB detected error (Load of NRCB failed)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment.
SNA: 2635 – (LS) An attempt to send a -RSP was rejected
(EC = %%%%)
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2636 – (LS) LU-LU Session no longer active
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment.
SNA: 2656 – SVC error - %%%%
Description: This message indicates internal software exceptions. Useful for
network analysts in determining status of environment. The % represents a
hexadecimal number.
SNA: 2801 – IPM Disconnect
Description: This message occurs as a result of a disconnect of an IPM channel to
ICS. The probable cause is that the ICS run has terminated.
SNA: 2802 – IPM Disconnect - Exception
Description: Internal software error in the SNA/net SNMP (Simple Network
Management Protocol) Submanaged Program. Caused by an exception condition
during IPM channel disconnection.
7436 0728–303 5–69