DCP Series Telcon Message Manual - Public Support Login - Unisys

Event 15 CONFIGURATION ERROR DETECTED / UNDEFINED
LSUB #00nn IS NOT CONFIGURED FOR TS #00cc
Description: This CENLOG refers to an error in DUC where it received an
initialization message for a Logical Subchannel (SESSN statement) that is not
configured for this DCP. The user may not be able to access a Termination System if
this session that is in error is the only session to the Termination System. An Out of
Order Reset is sent back to the sender. Telcon generates this CENLOG.
Action: From the NMS console, determine what the TS is that is sending the
message. This can be done by entering DISP TS = 00cc. Then either add a SESSN
statement to the Telcon configuration to match the LSUB number or remove the
configuration to match the LSUB number or remove the configuration from the TS
configuration.
NTRLPH
Description: This event occurs if an NTR site attempts to sign on using a full-duplex
site ID on a line that is configured as half-duplex. This sign-on attempt will not
succeed, and repeated attempts of such a sign on are logged in the same manner.
Other information is logged in the registers, but is applicable to debug only. Telcon
generates this CENLOG.
Action: The configuration on either the remote NTR site or for the DCP line being
used should be changed.
NTRV2P
Description: This event occurs if code in NTRV2R that has specifically been turned
off by the customer (to reduce memory requirements) was actually required. This is a
fatal error (to NTRV2R), resulting in the procedure being blocked or the Telcon
crashing. Other information is logged in the registers, but is applicable to debug only.
Telcon generates this CENLOG.
OSIIP–DUPLICATE DNS SUBNET
Description: More than one OSISN configuration statement processed defining a
DNS subnet. The OSIIP component of the OSITS program product generates this
CENLOG.
Reason: Configuration error.
OSIIP–FWD PDU FAIL
Description: A PDU could not be forwarded because the forwarding subnet is down.
OSITS requested output of message with no segmentation allowed. The OSITS
program product generates this CENLOG.
Reason: Network failure and invalid OSITS request, respectively.
5–78 7436 0728–303