DCP Series Telcon Message Manual - Public Support Login - Unisys

Sense Data
0894 Migration Support Error. The sender of the request is relying on migration
support that is not available. Bytes 2 and 3 may contain the following sense
code specific information.
0895 Control Vector Error. The RU contained a control vector that was in error.
0896 Control Vector Too Long.
0897 System Definition Mismatch. The requested function is not supported by the
receiver, or there is a mismatch between the sending and receiving system
definitions.
0898 Session Reset. The XRF session is being reset.
0899 Invalid Address. An address modifying a control function is invalid or outside
the range allowed by the receiver.
089A Invalid File or File Not Found. The requested file was not found or was found
to be an invalid file.
089B Session Correlation Exception. The session correlation procedure detected an
exceptional condition at the SLU.
089C Reserved.
089D Gateway Node Error Detected during Cross-Network Session Initiation.
089E Identified Data Object Already Exists.
08A0 Session Reset. An LU or PU is resetting an LU–LU session.
08A2 Resource Active. The requested function must be performed on an inactive
resource but the resource is active.
08A4 Token-Match Exception. Partial name matching is unsuccessful during the
required find or store operation. The canonical identifier involved in the
exception is reported in the FS server report.
08A6 Object Not Found. An exception has occurred when the general server
attempted to process the server object, but the server object could not be
found.
08FF Entered resource name cannot be found within SNA/net's own domain. ADJSA
has not been turned on.
7436 0728–303 D–19