30.01.2013 Views

DCP Series Telcon Message Manual - Public Support Login - Unisys

DCP Series Telcon Message Manual - Public Support Login - Unisys

DCP Series Telcon Message Manual - Public Support Login - Unisys

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Event 3 EVENT/ERROR DETECTED AT L3 (NETWORK)<br />

TROUBLE LINK DETECTED–TRUNK: trunkname<br />

Description: Node not allowed to establish neighbor communications over the<br />

named trunk, because neighbor communications have been disrupted too often in the<br />

past few minutes. <strong>Telcon</strong> generates this CENLOG.<br />

The CENLOG registers contain the network address of the node in the following<br />

manner:<br />

R8: Node number<br />

R9: Simple cluster number<br />

R10: Super cluster number<br />

R11: Subdomain number<br />

Action: Determine and correct the causes of the disruptions (for example, links going<br />

up and down and rebooting nodes).<br />

TRUNK Overflow Condition Detected–TRUNK: trunkname<br />

TSTN<br />

Description: The subnetwork the named trunk is using is saturated. This occurs<br />

because the capacity of the subnetwork is insufficient for the amount of data being<br />

routed through it. You may experience delay-induced timeouts and resets of<br />

connections whose data traverses this trunk. <strong>Telcon</strong> generates this CENLOG.<br />

Action: The system administrator must re-engineer the subnetwork the trunk is using<br />

to accommodate the amount of data being routed through it, or readjust the network<br />

topology and routing to reduce the amount of data traversing the trunk.<br />

Description: Received ADD QCT INDEX TO QUEUE LIST command from<br />

SYSTSTRK after the system initialization process completed. The ADD QCT INDEX<br />

command should have been sent during system initialization, not after. The command<br />

was processed. <strong>Telcon</strong> generates this CENLOG.<br />

UNCONFIGURED NEIGHBOR REJECTED–TRUNK: trunkname<br />

Description: Node not allowed to establish neighbor communication over the named<br />

trunk because of the trunk’s boundary restrictions. <strong>Telcon</strong> generates this CENLOG.<br />

The CENLOG registers contain the network address of the node as follows:<br />

R8: Node number<br />

R9: Simple cluster number<br />

R10: Super cluster number<br />

R11: Subdomain number<br />

Action: To establish neighbor communications with the node over the trunk, add a<br />

BOUNDARY parameter in the TRUNK configuration statement.<br />

7436 0728–303 13–71

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!