DCP Series Telcon Message Manual - Public Support Login - Unisys

PDNSVS
Event 15 CONFIGURATION ERROR DETECTED / UNDEFINED
Description: During line initialization (module PDNSVS) was unable to successfully
access one of its link-layer table (Z2$) entries. PDNSVS was unable to obtain a match
based on the LINE STE index contained in the line control block (LCB). This event
includes the LINE name.
R10: PDNGRP STE index
Attributes affected: Line event, LCB is in Register R11, Configuration event. The
X.25 PSCS program product generates this CENLOG. Procedure: PDNSVS.
Action: Online configuration changes to the LINE statement may require Telcon to
be restarted. If this event occurs after Telcon is restarted, then a software error has
either corrupted the LINE STE index in PDNSVS’s link- layer table or in the LCB.
RMVTR
RTC
Description: RMVTR detected an invalid configured value.
R12: TCB address
R13: Last subroutine call
Telcon generates this CENLOG.
Description: Route table could not be created/expanded properly for route control.
Telcon generates this CENLOG.
SNA: 230 - TG=index#: Station address error, Rcv Adr x%%%%
Description: This message occurs as a result of errors or events in the Transmission
Group Control (TGC) that controls lines between SNA/net and IBM subareas. %%%%
represents a hexadecimal number for the receiver address. The # is a TG index
number. The probable cause is a configuration problem.
SNA: 248 – TG=index#: Could not add PU to transmission group
Description: This message results from too many physical units in the transmission
group or an incompatible parameter for the physical unit. The # is a TG index
number.
7436 0728–303 5–81