Configuration Handbook - Kamami.pl

Configuring Cyclone FPGAsThe serial configuration devices can be programmed in-system by anexternal microprocessor using SRunner. SRunner is a software driverdeveloped for embedded serial configuration device programming thatcan be customized to fit in different embedded systems. The SRunner canread a Raw Programming Data file (.rpd) and write to the serialconfiguration devices. The programming time is comparable to theQuartus II software programming time.fFor more information about SRunner, see the “SRunner: An EmbeddedSolution for Serial Configuration Device Programming” white paper and thesource code on the Altera web site (www.altera.com).Figure 13–9. In-System Programming of Serial Configuration Devices(1) (1) (1)10 kΩ 10 kΩ 10 kΩCyclone FPGACONF_DONESerialConfigurationDevicenSTATUSnCONFIGnCEnCEON.C. (2)10 kΩV CC V CC V CCV CCDATADATA0DCLKDCLKnCSnCSOMSEL1ASDIASDOMSEL0GNDPin 1(3)ByteBlaser II10-Pin Male HeaderNotes to Figure 13–9:(1) Connect these pull-up resistors to 3.3-V supply.(2) The nCEO pin is left unconnected.(3) Power up the ByteBlaster II cable’s V CC with a 3.3-V supply.Altera Corporation 13–17January 2007 Cyclone Device Handbook, Volume 1