Configuration Handbook - Kamami.pl

Serial Configuration Devices (EPCS1, EPCS4, EPCS16, & EPCS64) FeaturesfffffFor more information on configuring Stratix III FPGAs in AS mode orother configuration modes, refer to the Configuring Stratix III Deviceschapter in volume 1 of the Configuration Handbook.For more information on configuring Cyclone III FPGAs in AS mode orother configuration modes, refer to the Configuring Cyclone III Deviceschapter in the Cyclone III Device Handbook.For more information on configuring Stratix II FPGAs in AS mode orother configuration modes, refer to the Configuring Stratix II & Stratix IIGX Devices chapter in volume 1 of the Configuration Handbook.For more information on configuring Cyclone II FPGAs in AS mode orother configuration modes, refer to the Configuring Cyclone II Deviceschapter in volume 1 of the Configuration Handbook.For more information on configuring Cyclone FPGAs in AS mode orother configuration modes, refer to the Configuring Cyclone FPGAschapter in volume 1 of the Configuration Handbook.Multiple devices can be configured by a single EPCS device. However,serial configuration devices cannot be cascaded. Check Table 4–1 toensure the programming file size of the cascaded FPGAs does not exceedthe capacity of a serial configuration device. Figure 4–4 shows the ASconfiguration scheme with multiple FPGAs in the chain. The first FPGAis the configuration master and has its MSEL[] pins set to AS mode. Thefollowing FPGAs are configuration slave devices and have their MSEL[]pins set to PS mode.Altera Corporation 4–11April 2007 Configuration Handbook, Volume 2